English:Music - Unit 1 - Music Year 9
Introduction
Turn musical signs into a plan other people can play. Read a pitched staff, interpret a chord chart and translate between percussion notation and a count grid.
Read a pitched staff from left to right
A staff has five lines. On a pitched staff, the clef determines how the lines and spaces correspond to notes. In treble clef the second line from the bottom is G4. The adjacent spaces either side represent F4 below and A4 above. Middle C, C4, is on the first small ledger line below the treble staff. Use the clef, then use the note’s position. Note stems point in different directions for layout and clarity. Their direction does not make a pitch higher or lower.

Notice the two time signatures in the image. In 4/4, count four crotchet beats per bar. A semibreve occupies four of those beats, a minim two, a crotchet one and a quaver half. In the last bar, 2/4 gives two crotchet beats. A crotchet, quaver and two semiquavers add up to 1 + ½ + ¼ + ¼ = 2. Its sharp and flat change pitches, while the shapes and beams supply timing information.
Use the Lincoln Learning Solutions video or this written route: find the clef, identify the staff position and then read how long the note lasts. Copy the two-beat calculation as a rhythm of your own starting on a suitable pitch. A named note on paper specifies a pitch. To evaluate your actual playing, record or listen to an attempt where you can.
Distinguish a melody from a chord instruction
A lead sheet commonly gives a melody and chord symbols. It gives an ensemble shared landmarks and leaves choices about how to voice or play the chord. A chord symbol above a bar represents harmony, while individual notes specify the melody. In our example, a bare C is a C major triad (C, E, G), Am is A minor (A, C, E) and G7 is G dominant seventh (G, B, D, F). The 7 in the chord name identifies an added chord tone. It does not count beats.
Here is our original four-bar lead sheet plan in a text layout. Each chord starts at the beginning of its bar and lasts for that bar in the exercise. The note-name and duration column specifies what a fully notated melody would show. The number after a note name indicates its octave, as in C4 for middle C. Read one bar together before a group attempt.
| Bar | Chord | Melody in playing order |
|---|---|---|
| 1 | C | C4 crotchet, E4 crotchet, G4 minim |
| 2 | Am | A4 minim, G4 quaver, E4 quaver, crotchet rest |
| 3 | G7 | D4 quaver, E4 quaver, F4 crotchet, D4 crotchet, B3 crotchet |
| 4 | C | C4 minim, E4 crotchet, C4 crotchet |
Work through bar 2. The A4 minim sounds across beats 1 and 2. G4 and E4 occupy the two halves of beat 3. Beat 4 is a crotchet rest in the melody while the backing can continue. In bar 3 the written B3 at the end is just below middle C and moves by one semitone to C4 in bar 4. The chord player might use a single low root, a repeated chord or a broken chord without changing where the chord symbols occur. For a practice attempt keep the counting and volume comfortable and make sure the melody can be heard.
Read percussion positions using a key
Percussion notation uses familiar note shapes and timings. In a drum-kit part, staff positions and noteheads can show which part of the kit plays, rather than acoustic pitch names. Find the legend for the score. In this activity, read a higher cross-head as closed hi-hat, a higher solid drum note as snare and the lowest solid drum note as kick. Other publications can use different positions or symbols, so check the supplied key.

The drums video from Drumeo introduces a beginner beat and fill. If you watch it, choose one moment to check which parts sound together. Use the figure and the written score-reading guide for the specific symbol assignment in this lesson. A person can also trace or tap the different parts at a desk without a drum kit.
Written route. Keep the hi-hat line on all eight half-beat slots, including the “and” between the numbered beats. The kick enters with the hat on 1 and 3, and the snare joins the hat on 2 and 4. The repeat signs ask you to return to the bar. Count one complete bar first. A second playing repeats the same ordered events.
Translate between a drum staff and a grid
A count grid lays the time positions out in order. It can make simultaneous events easy to see. Here are the starts from the written route. Hat means hi-hat, and a recorded name in the same row starts at the same time as the hat. Read one line at a time.
| Count | Sounds starting here |
|---|---|
| 1 | Hat and kick |
| And after 1 | Hat |
| 2 | Hat and snare |
| And after 2 | Hat |
| 3 | Hat and kick |
| And after 3 | Hat |
| 4 | Hat and snare |
| And after 4 | Hat |
Check three numbers independently. There are eight hat strikes per bar, two kicks and two snare strikes. That is twelve strikes across eight start positions. Several occur together, so the number of strikes does not lengthen the bar. With quaver subdivisions the result still fills four beats. If you repeat the bar twice in total, you have eight beats, sixteen hats, four kicks and four snares.
The printed tempo range is 80 to 160 crotchet beats per minute. At 80 beats per minute, four beats take 3 seconds. At 160 beats per minute, they take 1.5 seconds. Tempo changes how long the bar takes in seconds while metre and note values keep its beat count. Begin at a pace that lets you keep the parts clear.
To produce a new version, add a kick on the “and” after 3, while keeping the other starts unchanged. The new version has thirteen strikes in the same four beats. Mark the addition in the grid and use your local legend to place it on the percussion staff. A grid can leave out dynamics and articulation. Add a symbol and explain it if one strike should be louder or if a different part of the kit should play it.
Choose a notation that fits the rehearsal
Choose a task. For a pitched melody with more than one duration, give a treble-staff route or a precise text plan with an octave label and note value for each sound. For an accompaniment, place the chord symbol where that harmony starts. For a kit or tapping part, use a percussion legend and a half-beat grid. Each plan should state tempo or a comfortable count, where the bars begin, where sounds happen together and how the players stop or repeat.
Work in pairs if possible. Give a partner just your plan, ask them to point out or play two bars, and record one place where they needed more information. For example, the note E says little about duration and register by itself, and an unlabelled cross-head may leave a drum player unsure what they should strike. Revise just that part and retain both versions.
Use these four checks: correct pitch and duration for the melody, correct chord starts, a clear instrument key for the rhythm and enough timing information for a partner to follow. Evidence can come from a paper check, reading aloud or a comfortable rehearsal. Label what actually happened and describe a next choice that the notation could make clearer.
Interactive Tasks
Quiz: Test Your Knowledge
What does the treble clef help you identify? (The pitches associated with the staff lines and spaces.) (!The name of the percussion player.) (!The speed at which every musician must play.) (!The number of chords in a repeating form.)
Where is middle C in treble clef? (On the first ledger line below the staff.) (!On the middle line of the staff.) (!On the highest staff line.) (!On the second space above the staff.)
How many crotchet beats does the final 2/4 bar contain? (Two beats, adding the crotchet, quaver and two semiquavers.) (!Four beats because the opening bar says 4/4.) (!One beat because the notes share a staff.) (!Eight beats because a quaver can count in pairs.)
What does G7 mean in the lead sheet diagram? (A G dominant seventh chord with G, B, D and F.) (!Seven beats of silence after note G.) (!A G chord followed by seven notes of the melody.) (!The seventh fret is required.)
What happens in the melody on beat 4 of bar 2? (A crotchet rest takes the fourth beat.) (!An A4 minim begins at that moment.) (!The chord symbol cancels all rests.) (!Both quavers start on beat 4.)
Why read the key for a drum-kit part? (Its staff positions and noteheads map to kit sounds and can vary across editions.) (!A note’s position always names one fixed acoustic pitch.) (!The key automatically doubles the written number of beats.) (!Every instrument makes the same sound on a drum staff.)
Which sounds start together on beat 2 of the original groove? (Hat and snare.) (!Hat and kick.) (!Kick and snare with no hat.) (!All three sounds.)
How many strikes occur in one original practice bar? (Twelve strikes across eight start positions.) (!Eight strikes because there are eight half-beat slots.) (!Sixteen strikes because downbeats are counted twice.) (!Four strikes because the bar contains four beats.)
What happens if the added kick is played after beat 3? (The total rises to thirteen strikes while the length remains four beats.) (!It adds a fifth beat.) (!It removes the hi-hat throughout the bar.) (!The first three beats no longer count.)
Which change makes a note-name plan easier to rehearse? (Specify both octave and duration, for example E4 crotchet.) (!Remove the beat lengths and let every reader guess.) (!Write each note as the same unlabelled cross.) (!Erase all places where parts start together.)
Memory Game
| clef | a sign that determines how staff positions are read |
| ledger line | a short extra line for a note outside the staff |
| quaver | a note worth half a crotchet in the examples |
| lead sheet | a melody with guiding chord symbols for accompaniment |
| legend | a key that explains the meaning of symbols and positions |
| subdivision | division of a beat into smaller time units |
Drag and Drop
| A small line beneath the treble staff supports middle C | First ledger line below |
| The symbol tells the accompaniment to use G B D and F | G dominant seventh |
| One full silent beat in the melody of bar 2 | Crotchet rest |
| A start where two sounds occur at once | Simultaneous attacks |
| A guide assigning positions and noteheads to kit parts | Drum notation legend |
Crossword Puzzle
| Clef | Sign that fixes the reading of staff positions |
| Quaver | Note normally worth half a crotchet |
| Legend | Key to the symbols used in a part |
| Crotchet | One counted beat in the example 4/4 bars |
| Snare | Drum assigned to beats two and four here |
| Voicing | Arrangement of a chord’s notes across pitches or parts |
LearningApps
Optional extra practice. Choose an appropriate activity with your teacher. If the external collection is unavailable, use the native activities and independent tasks in this course.
Cloze Text
Open Tasks
Easy
- Identify pitch and position: Where is G4 on the treble staff? Name one adjacent staff pitch.
- Read one melody bar: Count the durations in bar 2 of the lead sheet plan.
- Read a drum key: What does the upper cross-head represent in the activity key?
- List events: Name the sounds that start together on beat 3.
Standard
- Check a time change: Show why the first and last bars of the staff example have different counted lengths.
- Plan an accompaniment: Write a four-bar chord plan that preserves the stated chord changes but uses a different accompaniment pattern.
- Translate a rhythm: Add one snare hit to an “and” slot in a copy of the grid. Describe the change in strikes and the length.
- Explain a useful instruction: Add an instrument key or time cue to a short plan so a classmate could follow it.
Advanced
- Pitched and unpitched parts: Create a two-bar plan for a pitched melody and one layer of percussion. Label notes, timing and the percussion legend.
- Compare representations: Explain where a pitch-and-duration table helps and where a staff or chart could carry more useful information.
- Verify a rewrite: Translate between a one-bar percussion grid and a written description. Check starts, overlap and duration against the source.
- Evaluate a rehearsal document: Give a classmate a plan, identify one ambiguity from their feedback or a paper review, and revise one instruction.
Learning Check
- Check that the notes fit: How do the note values fit 2/4 in the last pictured bar?
- Read chord and melody independently: What information is different between G7 and the melody notes written in bar 3?
- Verify the melody rests: How many beats sound in the melody in bar 2 if you count held notes for their full value?
- Check a percussion count: Why does the original pattern have twelve strikes but still last four beats?
- Improve the instrument key: Why might highlighting only the cross-head leave a part ambiguous?
- Transfer to a rehearsal: What must a second musician know to play your example with you?
Worked checks and assessment guidance
- The crotchet is 1 beat, the quaver is half, and each of the two semiquavers is a quarter. The total is 2 crotchet beats.
- G7 names the supporting harmony, with G, B, D and F. The melody lists precise starts, notes and durations, including E as a passing note between D and F.
- The minim lasts two, and two quavers last one together. The melody sounds for three beats and rests for one. The accompaniment can still sound during the rest.
- Eight hats, two kicks and two snares make twelve strikes. Each numbered beat also has a simultaneous kick or snare and hat. The time grid has eight half-beat positions, which total four beats.
- The player needs to know which kit sound is assigned and whether it should be open, closed or accented. Provide a legend for the particular score and keep the duration sign.
- Give the count and tempo, the pitches and durations or kit assignments, the entrance and stop/repeat cue, and what should sound together. Ask the musician to check one bar and refine the instruction they needed.
Learning evidence
Complete ten quick checks, translate one four-beat part and produce a rehearsal plan using at least two suitable forms of notation. Use one check by a classmate or an annotated paper review to revise the plan.
OER and Wikipedia
Department for Education, Key Stage 3 Music. The Open University, basic music theory, pitch, rhythm and harmony. Drumeo, drum notation and differences in symbol conventions. The four-bar lead sheet plan, practice transcription, modified groove and assessments are original classroom material. The source recordings are embedded from their respective channels.
Music notation example, Benjamin D. Esham, based on work by Dysprosia and Esham and re-rendered by Pnorcks, public domain as identified on Commons.
Eighth-note groove, Yuka2, CC0 1.0. Both diagrams are displayed as supplied by Commons.
Understanding the Music Staff by Lincoln Learning Solutions. A written route is included.
How To Play Drums (Beginner Drum Lesson) by Drumeo. A written route is included.
Linked learning areas
aiMOOC Projects
Schulfach+


aiMOOCs


aiMOOC Projekte


NEWSLernweltNOAH fragen